AP30.10-T-3022A | Lubricate joints of engine control system, check joints for freedom of movement and proper seating | 19.11.01 |
ENGINES 402, 441, 446, 447, 489
T30.10-0010-06
| Inspect | ||
1 | Check ball joints as well as lever and shaft bearings to make sure that they can move freely and are not worn | Do not lubricate plastic joints | |
2 | Press ball sockets of throttle linkage off the ball pins, pack with grease and press on again | With secured ball sockets: fit retainer again. | |
| Sheet 267.0 | ||
3 | Oil bearing points of all throttle control shafts, throttle control levers and open joints of throttle control linkage as well as cables | Accelerator pedal, relay lever, bell crank, throttle control shaft, throttle valve shaft as well as ball sockets and ball heads must operate easily and free of play | |
4 | Clean lubricating nipple. | ||
5 | Grease with grease gun until new grease emerges. | Remove surplus grease. The number of lubricating nipple depends on the vehicle version. | |
| Sheet 267.0 | ||
6 | Clean lubricating nipple after greasing. |