Revisions
On model 220 some changes have been made in the key programming
- Programming time has doubled because the programming operations in the EIS and ESM are accomplished one after another.
- The status of the ESM programming can be checked only by actuating the shift lever. No visual display possible.
- If the ignition is switched off before completion of the ESM programming, the programming is terminated and must be started again from the very beginning when the ignition is switched back on. The programming time is increased accordingly.
Programming a replacement key | Key on new key rail not yet used | ||
1 | Connect battery charger | ||
2 | Program replacement key in programming station. | The RF and IR remote controls function immediately. | |
It is possible to start the engine immediately. | |||
Electric shift lever module (ESM) releases shift lever immediately. | |||
STAR DIAGNOSIS is not required. | |||
Programming a replacement key | Key on old key rail already used | ||
1 | Connect battery charger | ||
2 | Program replacement key in programming station. | RF and IR remote controls function immediately. | |
3 | Insert replacement key into electronic ignition switch (EIS). | Red LED comes on | |
When the red LED goes out, programming of the replacement key in the EIS is finished. | |||
4 | Turn replacement key in EIS to position "Ignition ON". | The electric shift lever module (ESM) is supplied with power. The replacement key is programmed in the ESM. | |
Leave replacement key in position "Ignition ON" until ESM has released the shift lever (press brake pedal). |