ar9720p1500k

Preserving hollow cavities following repair

Typ ar · téma 97.20 · verze 0105 · 2000-06-05

Platí pro: MODEL 208.3 /4

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 3 Nástavba › 97 Utěsnění karosérie, protikorozní ochrana › 97.20 Konzervace — Řada 208 (modely 3**, 4**)

EinPAS 40 Konzervace/lakování › 40.20 Ochrana proti korozi › 40.20.40 Konzervace dutin — Řada 208 (modely 3**, 4**)

AR97.20-P-1500K

Preserving hollow cavities following repair

10.3.97

MODEL 208.3 /4

Preserving hollow cavities following repair

P97.20-0235-06

1 Engine hood

2 Front door-rubber retaining rail

3 Door channel, front door

4 Trunk lid

Preserving hollow cavities following repair

P97.20-0236-09

5 Cross member below windbreak

6 Longitudinal member, front left

7 Air/water channel

8 Cross member, front

Preserving hollow cavities following repair

P97.20-0237-09

9 Longitudinal member, outer front right

10 Connecting carrier, front right

11 Engine support

12 Consoles transverse link bearing

13 Cross member below pedal floor panel

14 Longitudinal member, outer rear right

Preserving hollow cavities following repair

P97.20-2001-09

15 A-pillars

16 Tunnel reinforcement

17 Wheel house passenger compartment

18 Cross member rear axle

19 Assembly mounting

20 Mounting diagonal struts on spare wheel recess
(model 208.4 only)

Preserving hollow cavities following repair

P97.20-2002-06

model 208.4 only

21 Rear window channel

22 Longitudinal member, lateral, inner

Fig. item, etc.

Work instructions

Danger!

Risk of explosion and poisoning through solvent vapors and gases. Risk of injury to eyes and skin when handling anti-corrosion agents

Do not spray anti-corrosion agent into flames or onto glowing-hot surfaces and keep away from ignition sources. Work only in well ventilated areas, wear protective respiratory mask.

AS97.00-Z-0001-01A

Notes on hollow cavity preservation

AH97.20-P-0001-01B

Processing instructions for hollow cavity preservation

AP97.20-P-0640-01A

Apply wax preservative on hatched areas only after sealing and painting work, but before assembly work.

Insert spray hose as far as possible into cavities and pull out slowly during spraying.

Spray hose must be stiff and jets must spray inclined to front and rear. Cavities must be dry.

Carry out repair preservation twice in succession after a flash-off time of 5 minutes.

Application temperature must not be below +15 °C.

Apart from the standard cavity preservation as shown, additional sealing measures may be required depending on area of repair.

Odkazované dokumenty