P88.40-0239-06
1 Windshield washer nozzles
2 Retainer
3 Special tool
4 Cover
5 Connectors
6 Water hose
7 Cable
8 Cable
9 Screws
10 Cable clips
11 Insulating mat clips
12 Gas-operated strut
| Removal, installation | ||
1 | Move engine hood to upright position | ||
2 | Place protective fender covers on fender | ||
3 | Remove windshield washer nozzles (1) by pulling out retainer (2), pull off water hose and connector | | |
4 | Unclip cover (4) and disconnect | ||
5 | Pull out cable (8) and unclip cable clips (10) | Replace damaged clips | |
6 | Pull water hose (6) out of engine hood together with cable (7) | ||
7 | Mark installation position of engine hood on engine hood hinges | This facilitates installation | |
8 | Unscrew screws (9) on engine hood | Secure engine hood with 2nd person | |
| When engine hood is replaced seal joints before painting | ||
9 | Remove engine hood with 2nd person and put down on suitable surface | Avoid damaging paint Installation: | |
When installing pay attention to correct fit, if necessary adjust engine hood | |||
10 | Reinstall in opposite order |
Engine hood
140 589 18 63 00
Puller hook