ar7240d1002ch

Remove/install emergency release unit

Typ ar · téma 72.40 · verze 0100 · 2014-07-22

Platí pro: MODEL 900.6 with CODE T16 (Right load compartment sliding door) with CODE T55 (Electric operation of sliding door on right) with CODE T63 (Electric sliding door(s) unlocking) Outer emergency release

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 3 Nástavba › 72 Dveře › 72.40 Ovládání dveří — Řada 900 (modely 6**)

EinPAS 29 Oprávnění k jízdě / zabezpečovací systém › 29.16 Zamykání/odemykání › 29.16.1 Základní informace — Řada 900 (modely 6**)

AR72.40-D-1002CH

Remove/install emergency release unit

18.6.14

MODEL

900.6

with CODE T16 (Right load compartment sliding door)

with CODE T55 (Electric operation of sliding door on right)

with CODE T63 (Electric sliding door(s) unlocking)

Outer emergency release

Remove/install emergency release unit

D72.40-0022-09

Danger !

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove bottom door trim

AR72.16-D-6610G

2

Mark position (1) of bracket in relation to bolts (arrows)

3

Remove bracket (1)

Lay bracket (1) into sliding door with microswitch connected.

4

Actuate lever (3) on inner emergency release (2)

Retainer (4) must arrest.

5

Actuate lever (6) on outer emergency release (5)

Installation: Retainer must arrest.

6

Remove bracket (7)

7

Remove bracket (8)

Lay bracket (8) into sliding door with components connected.

8

Pull outer emergency release (5) out of sliding door slightly.

9

Loosen bolt nipple (9)

Installation:
Do not tighten bolt nipple (9) too tightly.
Otherwise the control cable can be damaged.

10

Remove outer emergency release (5)

11

Install in the reverse order

12

Check adjustment of control cables. adjust if necessary

AR72.16-D-2214CH

Learn in electric sliding door

13

Close sliding door with switch on center console, open completely and then close again

Check

14

Perform function test

Odkazované dokumenty