D72.40-0022-09
Danger ! | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Remove bottom door trim | ||
2 | Mark position (1) of bracket in relation to bolts (arrows) | ||
3 | Remove bracket (1) | Lay bracket (1) into sliding door with microswitch connected. | |
4 | Actuate lever (3) on inner emergency release (2) | Retainer (4) must arrest. | |
5 | Actuate lever (6) on outer emergency release (5) | Installation: Retainer must arrest. | |
6 | Remove bracket (7) | ||
7 | Remove bracket (8) | Lay bracket (8) into sliding door with components connected. | |
8 | Pull outer emergency release (5) out of sliding door slightly. | ||
9 | Loosen bolt nipple (9) | Installation: | |
10 | Remove outer emergency release (5) | ||
11 | Install in the reverse order | ||
12 | Check adjustment of control cables. adjust if necessary | ||
Learn in electric sliding door | |||
13 | Close sliding door with switch on center console, open completely and then close again | ||
| Check | ||
14 | Perform function test |
Referenced documents
- ah6800n000101s Notes on carrying out repair work in the vehicle interior
- ar7216d2214ch Adjust cables of emergency release for sliding door
- ar7216d6610g Remove/install door panel of sliding door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
- as0000z001701a Risk of injury caused by scraping or cutting body parts on sharp vehicle parts