P68.30-2851-09
1 Side trunk paneling
2 Expanding clip
3 Bolt
S69/10 Trunk partition closed limit switch
4 Frame
5 Trunk lid seal
| Remove/Install | ||
1 | Remove retractable partition | ||
2 | Remove paneling from rear end center assembly | ||
3 | Actuate trunk partition closed limit switch (S69/10) in direction of arrow and fasten at this point with strips of adhesive tape | ||
4 | Remove expanding clips (2) | Installation: Replace damaged expanding clips (2). | |
Danger! | Risk of injury to fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/tailgate or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
5 | Position trunk lid in assembly position. | Put up tubular frame only to middle of frame (4) | |
| |||
In event of malfunction close Vario roof mechanically, see: | |||
Close Vario roof manually | |||
6 | Open bolt cover (3) with suitable screwdriver and unscrew bolt (3) | ||
7 | Open frame (4) and loosen side trunk paneling (1) from trunk lid seal (5) | Carefully open frame (4) (arrow).If the frame (4) is damaged, replace side trunk paneling (1) | |
Installation: Ensure that side trunk paneling (1) is seated properly below trunk lid seal (5) | |||
8 | Lift frame (4) at fender side and pull side trunk paneling (1) toward rear until the side trunk paneling (1) is detached from the mount of the partition | ||
9 | Pivot side trunk paneling (1) toward inside in the front area and remove from trunk | ||
10 | Install in the reverse order |
Support
170 589 04 63 00
Odkazované dokumenty
- ar6830p4785v
- ar6850p3000v
- ar7730p6235v
- ar8850p500001v
- as0000z001101a Nebezpečí poranění prstů přivřením nebo pohmožděním při demontáži, montáži a seřizování kapoty, dveří, krytů a posuvného střešního okna