B60.80-0070-09
1 | Lock | 6 | Cabin lock | |
2 | Torsion bar | Seta A | (Direction of fluted support removal) | |
3 | Fluted support | Seta B | (Movement to the vehicle left side) | |
4 | Fastening bolt | Seta C | (Movement for torsion bar removal) | |
5 | Regulating screw |
| Remove/install | ||
1 | Remove front grille | Remove/install front grille | |
2 | Remove torsion bar (2) lock (1) | ||
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
3 | Fix the safety cables in the cabin | ||
Cable set | |||
4 | Tilt the cab | ||
5 | Loosen the adjustment screw (5) and remove the fluted support (3) clamping bolt (4) | Mark the original position of the adjustment screw (5) to facilitate adjustment after replacing the torsion bar (2). | |
Grooved support attachment bolt | |||
6 | Move (Arrow A) the fluted support (3) in the torsion bar (2) | ||
7 | Move the torsion bar (2) to the vehicle left side (Arrow B) | If necessary, use an appropriate tool as support and a lever to move the torsion bar. | |
8 | Remove the torsion bar (2) by the opening of the front grille (Arrow C) | ||
9 | Install on the reverse order | ||
| Measure | ||
10 | Measure the adjustment distance (A) in the cabin lock (6) | Adjustment distance (A) for the cab locking | |
If the distance (A) is not according to prescribed: | |||
| |||
Adjust the torsion bar pressure (2) by loosening or tightening the regulating screw (5). | |||
| Check | ||
11 | Check the system for the good functioning. | Tilt the cabin by 3 times | |
In case of malfunctioning of the system: | |||
| |||
Return to the step 10. |
970 589 00 31 00
Cable set
Odkazované dokumenty
- ar6080b0010d
- ar6080b100004ta
- ar8800b2115b
- as6080z000101a Nebezpečí úrazu v důsledku přivření a přiskřípnutí při sklápění kabiny řidiče