Test and adjustment values, gap dimensions on hoods, doors and covers
Number | Designation | Model 638 | |||
BE60.00-N-1001-01A | Gap dimensions between | Engine hood and fenders | Dimension "A" | mm | 6.01 |
See figure | |||||
BE60.00-N-1002-01A | Gap dimensions between | Front door and A-pillar | Dimension "B" | mm | 6.01 |
Front door and roof | Dimension "C" | mm | 8.01 | ||
Front door and top of sliding door | Dimension "D" | mm | 7.01 | ||
Front door and bottom of sliding door | Dimension "E" | mm | 7.01 | ||
Front door and top of side wall | Dimension "F" | mm | 6.01 | ||
Front door and bottom of side wall | Dimension "G" | mm | 6.01 | ||
Front door and rocker panel | Dimension "H" | mm | 6.01 | ||
Front door and wheelhouse | Dimension "I" | mm | 6.01 | ||
See figure | |||||
BE60.00-N-1003-01A | Gap dimensions between | Sliding door and top of C-pillar | Dimension "K" | mm | 7.01 |
Sliding door and bottom of C-pillar | Dimension "L" | mm | 7.01 | ||
Sliding door and roof | Dimension "M" | mm | 8.01 | ||
Sliding door and rocker panel | Dimension "N" | mm | 6.01 | ||
See figure | mm | ||||
BE60.00-N-1004-01A | Gap dimensions between | Rear door and roof | Dimension "O" | mm | 7.01 |
to D-pillar | Dimension "P" | mm | 7.01 | ||
See figure | |||||
BE60.00-N-1005-01A | Gap dimension | Tank flap | Dimension "Q" | mm | 4.01 |
See figure | |||||
129 589 03 21 00
Feeler gage
S60.00-1001-09
S60.00-1002-09
Note
Adjust hood, doors and covers according to drawings. The gap should not be wedge shaped or narrower at spots. Gaps should not deviate from parallel by more than 0.5 mm over the entire length. If inside width of opening is too great or too small align movable body parts as required. The guide values apply only for repair work to bodies damaged in an accident.