Test and adjustment values for gap dimensions at hoods, doors and covers |
Number | Designation | MODEL 210.0 | |||
BE60.00-P-1001-01A | Gap dimension | Engine hood to fender | Dimension "A" | mm | 4,0 (0,5) |
Engine hood to headlamp | Dimension "R" | mm | – | ||
Engine hood to radiator grille | Dimension "O" | mm | – | ||
Radiator grille to headlamp | Dimension "N" | mm | – | ||
For picture, see | |||||
Test and adjustment values for gap dimensions at hoods, doors and covers |
Number | Designation | MODEL 210.0 | |||
BE60.00-P-1002-01A | Gap dimension | Front door to A-pillar | Dimension "B" | mm | 6,5 (0,5) |
Front door to fender | Dimension "H" | mm | 4,5 (0,5) | ||
Front door to rear door | Dimension "I" | mm | 5,5 (0,5) | ||
Front door to roof | Dimension "C" | mm | 6,5 (0,5) | ||
Rear door to side section, top | Dimension "D" | mm | 6,5 (0,5) | ||
Rear door to side section, bottom | Dimension "J" | mm | 4,0 (0,5) | ||
Fender to A-pillar | Dimension "Q" | mm | – | ||
Front door to rear fender | Dimension "P" | mm | – | ||
For picture, see | |||||
Test and adjustment values for gap dimensions at hoods, doors and covers |
Number | Designation | MODEL 210.0 | |||
BE60.00-P-1003-01A | Gap dimension | Trunk lid to rear fender, top | Dimension "F" | mm | 4,5 (0,5) |
Trunk lid to rear fender, bottom | Dimension "M" | mm | 4,5 (0,5) | ||
Trunk lid to rear fender | Dimension "F" | mm | – | ||
Trunk lid to taillamp | Dimension "M" | mm | – | ||
Trunk lid to bumper | Dimension "V" | mm | – | ||
Rear fender to taillamp | Dimension "U" | mm | – | ||
For picture, see | |||||
129 589 03 21 00
Feeler gauge
1 | Adjust hoods, doors and lids as shown in drawing . |
The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents. |
P60.00-0480-06