Test and adjustment values for gap dimensions
Number | Designation | Model | |||
BE60.00-P-1001-01N | Gap dimension | Engine hood to fender | Dimension "A" | mm | 4.0 (1) |
Engine hood to headlamp | Dimension "B" | mm | 4.0 (1) | ||
Headlamp to fender | Dimension "C" | mm | 4.0 (1) | ||
Engine hood to bumper | Dimension "D" | mm | 5.0 (+2.5) | ||
Headlamp to bumper | Dimension "E" | mm | 3.0 (1) | ||
Fender to A-pillar | Dimension "F" | mm | 3.0 (1) | ||
For picture, see | |||||
BE60.00-P-1002-01N | Gap dimension | A-pillar cover to front door | Dimension "G" | mm | 6.5 (-0.5/+1) |
Front door to fender | Dimension "H" | mm | 4.0 (1) | ||
Front door to rear door, bottom | Dimension "I" | mm | 4.0 (1) | ||
Front door to rear door, top | Dimension "J" | mm | 4.0 (1) | ||
Front door to A-pillar | Dimension "K" | mm | 6.5 (-0.5/+1) | ||
For picture, see | |||||
BE60.00-P-1003-01N | Gap dimension | Rear door to side roof paneling | Dimension "L" | mm | 6.5 (1) |
Rear door to rear fender | Dimension "M" | mm | 4.0 (1) | ||
Rear door to rear side window | Dimension "N" | mm | 6.5 (-0.5/+1) | ||
Rear fender to taillamp | Dimension "O" | mm | 2.5 (0.5) | ||
Rear fender to rear-end door | Dimension "P" | mm | 4.0 (1) | ||
For picture, see | |||||
BE60.00-P-1004-01N | Gap dimension | Front fuel filler flap | Dimension "Q" | mm | 4.5 (0.5) |
Rear fuel filler flap | Dimension "R" | mm | 4.0 (0.5) | ||
For picture, see | |||||
BE60.00-P-1005-01N | Gap dimension | Bumper to taillamp | Dimension "S" | mm | 2.5 (1) |
Rear-end door to taillamp | Dimension "T" | mm | 4.0 (1.5) | ||
Rear-end door to bumper | Dimension "U" | mm | 5.0 (2) | ||
Rear-end door to roof | Dimension "V" | mm | 4.5 (1) | ||
For picture, see | |||||
BE60.00-P-1006-01N | Gap dimension | Front door to rear fender, bottom | Dimension "X" | mm | - |
Front door to rear side window | Dimension "Y" | mm | - | ||
For picture, see | |||||
Feeler gauge
129 589 03 21 00
P60.00-2564-06
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2567-09