Jacket tube
Number | Designation | Model 210 | ||
BA46.10-P-1005-03D | Gearbox of height adjustment up/down motor to jacket tube | 1st stage | Nm | 8 |
2nd stage | Nm | 3 | ||
Assembly note | See | |||
BA46.10-P-1006-03D | Console to jacket tube | 1st stage | Nm | 8 |
2nd stage | Nm | 3 | ||
Assembly note | See | |||
BA46.10-P-1007-03D | Bolt of clamping nut | Nm | 6 | |
BA46.10-P-1012-03D | Gearbox of height adjustment up/down motor to console | Nm | 10 | |
P46.10-2114-01
Detaching
1 Unclip longitudinal adjustment forward/back motor connector (M20x1). To do this, press the lug (arrow) to the left.
P46.10-2115-02
2 Loosen bolt of clamping nuts (87e) and unscrew clamping nuts.
3 Remove bolts (87d) with guide bushes.
4 Remove console (87).
Attaching
5 Mount console (87).
6 Insert bolts (87d) and guide bushes.
Check guide bushes and replace if necessary.
7 Screw on clamping nut (87e) and attach bolt of clamping nut.
The smooth surface of the clamping nut (87e) must point outwards.
8 Tighten bolts (87d), loosen again and retighten, observing the specified tightening torques.
9 Tighten bolt of clamping nut (87e).
10.1 If the gearbox of the height adjustment up/down motor has been removed; align the jacket tube. Tighten the bolts (60a) on the right-hand side. Press the left-hand side slightly to the right with a screwdriver above the spring (arrow) and tighten bolts (60a).
11 Clip on longitudinal adjustment forward/back motor connector (M20x1).