1 | Steering wheel |
2 | Nut |
3 | Cover |
G46.10-3117-11
| Remove/install | ||
1 | Turn steering wheel (1) to straight-ahead position | ||
2 | Switch off ignition | ||
3 | Remove cover (3) from steering wheel (1) | ||
4 | Mark position of steering wheel (1) relative to the steering column | If the identification on the steering wheel (1) and steering shaft made at the factory is not present. | |
5 | Unscrew nut (2) and manually detach steering wheel (1) | Installation: Observe markings (arrow) on steering wheel (1) and steering column. | |
Nut, steering wheel to steering column | |||
6 | Install in the reverse order | ||
7 | Conduct a road test | During the test drive, check the turn signal cancellation function and the position of the steering wheel (1). | |
If the steering wheel (1) is at an incline | |||
| |||
Move steering wheel by one tooth at most or if deviation is greater, check the center steering position on the steering gear. | |||
| |||
|