I42.60-0107-06
1 Separate compressed-air reservoir
2 Compressed-air line
3 Banjo bolt
4 Sealing ring
5 Bracket
6 Washer
7 Nut
8 Retaining strap
| Remove/install | ||
1 | Secure vehicle against rolling | ||
2 | Depressurize air brake system | Pull vent valve on compressed-air reservoir. | |
3 | Clean connection of compressed-air line (2) | ||
4 | Detach compressed air line (2) from separate compressed-air reservoir (1) | Installation: Install new sealing rings (4). | |
| |||
5 | Use suitable plug to seal open connection on separate compressed-air reservoir (1) | To prevent dirt ingress. | |
6 | Remove both tensioning straps (8), and remove separate compressed-air reservoir (1) | | |
7 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
8 | Charge air brake system | Allow the engine to run until the operating pressure of the air brake system is reached. | |
If the pressure regulator fails to stop filling the air brake system after reaching the operating pressure: | |||
Check shutoff pressure of pressure regulator, adjust if necessary. |
Test values for service brake
Brakes, pneumatic system
Odkazované dokumenty
- ar4260i0020b
- as0000z000501a Nebezpečí úrazu při samovolném rozjetí vozidla při běžícím motoru. Nebezpečí poranění pohmožděním a popálením při výkonech prováděných během startování nebo při běžícím motoru