N42.60-2095-06
1 Quick-release valve
2 Compressed-air line
3 Compressed-air line
4 Compressed-air line
5 Banjo bolt
6 Banjo bolt
7 Union nut
8 Bolts
9 Bracket
| Remove/Install | ||
1 | Secure vehicle against rolling | ||
2 | Depressurize air brake system | Pull vent valve on compressed-air reservoir. | |
3 | Clean connections of compressed-air lines (2, 3, 4) | ||
4 | Mark compressed-air lines (2, 3, 4) | Installation: Observe installation position of compressed-air lines (2, 3, 4). | |
5 | Remove banjo bolts (5, 6) and take off compressed-air lines (2, 4). | Installation: Install new sealing rings. | |
| |||
6 | Unscrew union nut (7) and remove compressed-air line (3). | | |
7 | Plug connections of compressed-air lines (2, 3, 4) with suitable plugs. | To prevent dirt ingress. | |
8 | Remove bolts (8) at bracket (9) and take off quick-release valve (1). | | |
9 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns when working in engine during starting procedure | Secure vehicle to prevent it from moving. | |
10 | Allow the engine to run until the air brake system comes up to pressure. | ||
11 | Check pressure regulator cutoff pressure, adjust if necessary |
Brakes pneumatic system
Odkazované dokumenty
- ar4260i0020b
- as0000z000501a Nebezpečí úrazu při samovolném rozjetí vozidla při běžícím motoru. Nebezpečí poranění pohmožděním a popálením při výkonech prováděných během startování nebo při běžícím motoru