Carry out distance and comparison measurements on front and rear axles

AR40.30-P-0402SR

Carry out distance and comparison measurements on front and rear axles

04.08.2016

Model

453

Shown on model 453.3

A1

Test course

A2

Test course

B1

Test course

B2

Test course

C1

Test course

C2

Test course



Remove

 Danger !

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle with vehicle lift

2

Remove underfloor panels

3

Remove cross strut

Model 453.44/45/46

AR61.10-P-5139SRC



Measure

4

Determine length of measurement distances (B1, B2) and compare with each other

 The permissible deviation between the measurement distances (B1, B2) may not be exceeded.

Permissible variation between measurement distances

*BE40.30-P-1001-10C

 Gage

*450589002300

If permissible deviation is exceeded:



Define corresponding repair measures

5

Determine length of measurement distances (A1, A2) and compare with each other

 The permissible deviation between the measurement distances (A1, A2) may not be exceeded.

Permissible variation between measurement distances

*BE40.30-P-1001-10C

 Gage

*450589002300

If permissible deviation is exceeded:



Define corresponding repair measures

6

Determine length of measurement distances (C1, C2) and compare with each other

 The permissible deviation between the measurement distances (C1, C2) may not be exceeded.

Permissible variation between measurement distances

*BE40.30-P-1001-10C

 Gage

*450589002300

If permissible deviation is exceeded:



Define corresponding repair measures



Install

7

Install cross struts

Model 453.44/45/46

AR61.10-P-5139SRC

8

Install underfloor paneling

9

Lower vehicle

Distance measurement and comparative measurement

Number

Designation

Model 453

BE40.30-P-1001-10C

Permissible variation between measurement distances

A1 and A2

mm

4

B1 and B2

mm

4

C1 and C2

mm

4

For picture, see

AR40.30-P-0402SR