055 | Holding device |
055b | Mounts |
10 | Tie rod |
10f | Jam nut |
P40.20-0307-01
D40.20-0047-01
030 | Wheel pressure tester |
P40.20-2034-11
| Check | ||
1 | Determine actual and specified values of the track width at the front axle | ||
Take the specified values for the track width from the nomogram using the determined vehicle level and make a note of them. | |||
Adjust | |||
2 | Fix steering wheel in center position | Swivel the sun visor to the side and install the holding device (055). | |
Tensioning nut | |||
Retainer device | |||
3 | Check center position of steering gear and steering wheel | The steering gear is centered when the marking on the cap is aligned with the mark on the control valve housing. | |
Adjust steering wheel by max. one tooth if necessary, see: | |||
| |||
Remove/install steering wheel | |||
4 | Install wheel spreader (030) | Install wheel spreader (030) at the front on the inside of the wheel (in the direction of travel). | |
The elastic bearing of the lower transverse control arm and steering linkage produces a correspondingly large toe value that is reduced to the correct dimension in the ready-to-drive condition. | |||
5 | Loosen jam nuts (10f) | ||
6 | Set track width accordingly to the determined specified values by twisting the tie rods (10) | Observe permissible difference in front axle toe-in between right and left sides of the vehicle. | |
Check that the bellows are not twisted after adjusting the toe-in. | |||
Toe-inToe-in | |||
Lock nut at ball head | |||
7 | Remove holding device (055) | ||
8 | Remove wheel pressure tester (030) | ||
| Check | ||
9 | Carry out final measurement |
129 589 01 21 00
Retainer device
906 589 00 21 00
Tensioning nut