Modification notes
Test values for rear axle differential
Number | Designation | Model | Model Model 211.004 with code 450 | ||
BE35.31-P-1003-03C | Crown wheel heating temperature for installation | °C | 75...85 | 75...85 | |
Test values for rear axle differential
Number | Designation | Model | Model | ||
BE35.31-P-1003-03C | Crown wheel heating temperature for installation | °C | 75...85 | 75...85 | |
Rear axle center assembly crown wheel
Number | Designation | Model | Model | Model | ||
BA35.31-P-1001-03F | Retaining bolt, ring gear to differential case | Nm | 85 | 85 | 85 | |
Rear axle center assembly crown wheel
Number | Designation | Model | ||
BA35.31-P-1001-03G | Retaining bolt, ring gear to differential case | Nm | 140 | |
124 589 07 21 00
116 589 18 61 00
Spring compressor
Remote thermometer
P35.31-0282-01
1 Carefully clean the ring gear bore as well as the ring gear seat on the differential case.
2 Heat ring gear (47a) to installation temperature using heating plate (080). Check temperature constantly using remote thermometer (070).
P35.31-0283-01
3 Using assembly mandrel (046), clamp differential case in vise.
4 Put on suitable heat protection gloves, mount ring gear (47a) on the differential case and apply some light hammer blows (rubber-headed hammer) if necessary.
Pay attention to any markings (arrow) applied to the ring gear (47a) and differential case.
P35.31-0284-01
5 Tighten ribbed retaining bolts (13a) for securing the ring gear (47a) evenly and in a cross pattern.
Safety bolts with ribs (13a) must always be replaced after being used once.