Inspection data of rear axle final drive
Number | Designation | Rear axle | Rear axles | ||
BE35.30-N-1002-01L | Axial play of intermediate gear of portal axle final drive | mm | 0,05...0,08 | 0,01...0,05 | |
001 589 53 21 00
Dial indicator
Dial indicator holder
363 589 02 21 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1036-12A | Plug gauge, Firma Zahnradfabrik Passau GmbH D-94034 Passau | |
WH58.30-Z-1025-14A | Pry bar |
Workshop equipment
WE58.40-Z-1001-12A | Stationary workshop press 65 t |
T35.30-0063-01
1 Complete the intermediate gear with bearing bolts.
When reusing intermediate gears which have already run the assignment and installation position of the separate parts is to be observed.
2 Fit shim on bearing pin.
When using the shim found beforehand during disassembly in our experience the required adjustment values result, however a check is imperative.
T35.30-0064-01
3 Position feeler on shim.
4 Insert intermediate gear complete with tapered roller bearing, bearing bolts, shim and measuring drift into a suitable workshop press.
5 Fasten dial indicator on dial indicator holder and position so that the tracer pin of the dial indicator can be mounted on the end face of the intermediate gear.
6 Apply a press-on force of 10.000 N to the intermediate gear bearing.
7 Using two pry bars on the lower end face carefully move the intermediate gear axially and in the process read off the value for axial play on the dial indicator .
Move the intermediate gear carefully in order to avoid damaging it.
Correct the axial play if necessary by installing the corresponding shim.
8 Remove intermediate gear from the workshop press.
9 Drive out bearing bolts from the intermediate gear.