Test and adjustment values for gear set
Number | Designation | Trans-mission | Trans-mission | ||
BE26.50-N-1003-01F | Preload of main shaft tapered roller bearing | mm | 0...-0.15 | 0...-0.15 | |
366 589 00 21 05
Pliers
Extension
Dial indicator
Assembly stand
001 589 53 21 00
715 589 00 37 00
712 589 01 31 00
D26.60-1198-02
1 Slide shift rail (1) downwards through the opening on the front part of the transmission housing.
This in turn serves to engage the 5th. gear on the transmission.
D26.50-1274-12
2 Screw bolt (8) into main shaft (2).
3 Tighten washer (3) with nut (4) on the main shaft (2).
4 Mount dial indicator (7) with extension (6) onto assembly stand (9).
5 Push main shaft (2) upwards by turning the bolt (5), while also using the pliers to spin the drive shaft several times.
The reference value for the bolt (5) is approx. 15 Nm. Repeat operation step at least 3-times.
6 Rotate main shaft (2) by turning the drive shaft using the pliers until the mark (arrow) on the washer (3) lines up with the extension (6).
7 Set dial indicator (7́) to zero.
8 Pull main shaft (2) down by turning the bolt (5), while using the pliers to spin the drive shaft several times.
The reference value for the bolt (5) is approx. 15 Nm. Repeat operation step at least 3-times.
9 Rotate main shaft (2) by turning the drive shaft using the pliers until the mark (arrow) on the washer (3) lines up with the extension (6).
10 The value shown on the dial indicator (7) is the required thickness for the shims to be installed.
11 Remove dial indicator (7) and extension (6).
12 Remove bolts (5, 8).