D26.50-0117-12
1 Input shaft
2 Lock-ring
3 Input shaft bearing
4 Gearbox front end case
5 Lock-ring
| Remove | ||
1 | Removing the gearbox case | ||
2 | Remove the center actuation device | ||
3 | Remove the input shaft radial seal | ||
4 | Remove the lock-ring (5) | ||
5 | With an appropriate drift remove, with pressure, the input shaft (1) | Utilize an appropriate bushing in the inside at the lock, thus avoiding possible breakage of the gearbox case. | |
6 | Push back the bearing of the input shaft (3) | This way, the lock-ring (2) will be free again. | |
7 | Remove the lock-ring (2) | ||
8 | Remove, with drift strikes, the bearing of the input shaft (3) | ||
| Installing | ||
9 | With pressure, install the bearing of the input shaft (3) with an appropriate drift until making contact with the support seat in the front case of the gearbox (4) | Replace input shaft bearing.Observe the position of the guide on the support seat (arrow). | |
10 | Check the clearance of the input shaft bearings | In the case of having replaced the gearbox front case. Replace also the lock-ring. | |
11 | With pressure, install the input shaft (1) | The inside race of the input shaft bearing will have to rest with the pressure assembly device. | |
| |||
12 | Install the lock-ring (5) | ||
13 | Install the input shaft radial seal | ||
14 | Install the center actuation device | ||
15 | Assemble the gearbox case |
711 589 01 43 00
Pressure insertion device