G26.20-3192-11
1 Turn buckle
2 Jam nut
3 Gearshift lever
4 Rubber bushing
a Adjustment dimension of turnbuckle
(guideline value = 127 mm)
Adjust | |||
1 | Print out form for test values | ||
| Measurement table for EPS transmission, form | ||
2 | Check adjustment dimension of turnbuckle (a); adjust as per guideline value (127 mm) | Measure the adjustment dimension of the turnbuckle (a) from bolt center to bolt center. To adjust the turnbuckle (1), loosen the jam nuts (2) and tighten again after adjustment. | |
3 | Switch ignition to "ON" position | See the Operator's Manual . | |
4 | Call up test value No. 14 in instrument cluster | Call up the main menu for diagnosis of gear control measured values in the selection menu, see operator's manual . | |
5 | Shift to 4th gear at Telligent shift control unit, read out measurement value 14 and enter in measurement table for adjusting range group | ||
6 | Perform test drive over short distance | ||
7 | During test drive, shift to 5th gear at Telligent shift control unit, read out measurement value 14 and enter in measurement table for adjusting range group | The 5th gear can only be engaged while the vehicle is being driven. | |
8 | Park vehicle and switch ignition to "ON" position | ||
9 | Call up measurement value no. 14 in instrument again | Call up the main menu for diagnosis of gear control measured values in the selection menu, see operator's manual . | |
10 | Detach turn buckle (1) from shift lever (3) | ||
11 | Move gearshift lever (3) toward rear, read out GC measurement value 14 and enter in measurement table for adjusting range group | Ask a second person for assistance. Shift the shift lever (3) backwards by hand using an extension pipe, push all the way backwards and hold. | |
12 | Move gearshift lever (3) toward front, read out GC measurement value 14 and enter in measurement table for adjusting range group | Ask a second person for assistance. Shift the shift lever (3) forwards by hand using an extension pipe, push all the way forwards and hold. | |
13 | Attach turnbuckle (1) to gearshift lever (3) | ||
14 | Calculate adjustment values in measurement table | ||
15 | Compare results from measurement table with measurement value 14 on instrument; adjust turnbuckle (1) if necessary | To adjust the turnbuckle (1), loosen the jam nuts (2) and tighten again after adjustment. The rubber mounts (4) must be parallel to each other. | |
16 | Perform minor teach-in process |