W25.10-1102-09
1 | Clutch pressure plate unit | 5 | Clutch plate | 9 | Assembly device | ||
2 | Bolts | 6 | Cone ring with intermediate disk | 10 | Release bearing | ||
3 | Centering drift | 7 | Clutch plate | 11 | Guide bearing | ||
4 | Flywheel | 8 | Clutch pressure plate |
| Remove | ||
1 | Remove engine or transmission | Select procedure according to design and accessibility. | |
2 | Insert centering drift (3) into guide bearing (11) in flywheel (4) | Centering drift | |
3 | Loosen screw/bolts (2) | Loosen bolts (2) in small increments in a crosswise pattern. This prevents any one-sided strain on the clutch pressure plate unit (1). | |
4 | Mount assembly device (9) onto clutch pressure plate (8) | ||
| 000 588 00 61 00 Assembly device | ||
5 | Remove bolts (2) uniformly | ||
6 | Lift up clutch pressure plate (8) with assembly device (9) | ||
7 | Remove clutch plate (5) | ||
8 | Remove assembly device (9) | Only if clutch pressure plate unit (1) is to be replaced. | |
9 | Check clutch parts for wear and damage | ||
| Clean | ||
10 | Clean profile grooves in clutch plate (5). | Only when clutch plate (5) is not to be replaced. | |
| |||
11 | Clean sleeve in clutch release bearing (10) | Only if clutch pressure plate (8) is not to be replaced. | |
12 | Clean guide bearing (11) in flywheel (4), guide tube on transmission and the hub profile on the transmission input shaft | | |
| Install | ||
13 | Insert centering drift (3) into guide bearing (11) in flywheel (4) | Centering drift | |
14 | Center clutch plate (5) on flywheel (4) over the centering drift (3) | ||
15 | Mount assembly device (9) onto clutch pressure plate unit (1) | Only if clutch pressure plate unit (1) is to be replaced. | |
| 000 588 00 61 00 Assembly device | ||
Before installation of the new clutch pressure plate unit (1) check whether the diaphragm spring reeds are correctly seated into the clutch bearing (10). | |||
16 | Install assembled clutch pressure plate unit (1) using assembly device (9) above centering drift (3) | A new clutch pressure plate unit (1) is supplied in adjusted form. | |
17 | Tighten the bolts (2) in small stages in a crosswise pattern | While tightening ensure that the centering drift (3) can still be moved easily. | |
Clutch pressure plate to flywheel | |||
18 | Remove assembly device (9) | ||
19 | Remove centering drift (3) | Centering drift | |
20 | Install engine or transmission | ||
21 | Connect diagnostic system, start Xentry and perform quick test | ||
22 | Teach in clutch travel in drive control (FR) control unit | Only when clutch pressure plate (8) or clutch plate (5) is to be replaced. | |
23 | End XENTRY and disconnect diagnostic system |
950 589 00 61 00
Centering drift