Remove/install starter

AR15.30-P-7100CS

Remove/install starter

15.2.12

3.9.03

Check ring gear - added

Operation step 7

 

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Disconnect ground line from battery

 Insulate ground line as a protection against unintentional contact of dismounted ground line with ground point of battery.

Model 129

AR54.10-P-0003A

Model 211.0

AR54.10-P-0003T

Model 211.2

AR54.10-P-0003TA



Notes on battery

AH54.10-P-0001-01A

2

Detach lower engine compartment paneling

Model 129

AR61.20-P-1105AB

Model 211

AR61.20-P-1105T

3

Detach electrical lines (1, 2)

 Nut for connection circuit 30

*BA15.30-P-1001-01A

 Nut for connection circuit 50

*BA15.30-P-1002-01A

4.1

Detach right engine mount from engine support

 Remove bolt at engine mount, lightly raise engine and place engine mount to the side.

Model 211.270

Model 211.070

AR22.10-P-1100PV

5

Remove bolt (3)



*BA15.30-P-1003-01A

6

Remove starter (M1) from the side

7.1

Check ring gear at flywheel for wear and damage

When replacing the starter on vehicles fitted with manual transmission

 Rotate engine at crankshaft in direction of rotation.

7.2

Check ring gear on drive plate for wear and damage

When replacing starter on vehicles fitted with automatic transmission

 Rotate engine at crankshaft in direction of rotation.

8

Install in the reverse order

9

Carry out function check

10

Render electrical system operational

See: 

Model 129

AR00.19-P-0200A

Model 211

AR00.19-P-0200T

11

Read out fault memory and erase

 When the work is complete stored faults must be worked on in the diagnostic trouble code memories and erased. 



Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

Number

Designation

Engine
112 except 112.951, 113.94/
96/98

BA15.30-P-1001-01A

Nut, connection for circuit 30

Nm

14

BA15.30-P-1002-01A

Nut, connection for circuit 50

Nm

6

BA15.30-P-1003-01A

Bolt connecting starter to crankcase

Nm

42