AR14.40-B-2050B | Remove/install sieve on metering device compressed air inlet for EATS | 12.02.16 |
Cumbustion engine 457.90 with Vehicle 382.15, 634.0 with CODE MS5 (BlueTec 5)
W14.40-1518-08
1 Metering unit
2 Compressed air line
3 Screen
4 Screwdriver
5 Compressed air inlet
| Remove/install | ||
Danger! | Risk of injuries by pinching and crushing when tilting the cab | During the cab tilting and returning, do not get under the tilting area and take the preventive measures to impede the access of non authorized people. Always tilt the to its final position and latch it with the safety device. | |
| Indications on cab tilting | ||
1 | Cab tilting | ||
2 | Remove the compressed air inlet duct (2) on the metering unit (1) | Wait until the pressure is released before starting any job in the exhaust gas aftertreatment system. | |
Seal the orifice with an adequate plug. | |||
Installing: Before assembly, inspect the connection of the compressed air duct (2) for impurities, contaminants and damages. | |||
| |||
3 | Remove the screen (3) utilizing a screwdriver (4) | ||
4 | Install in reverse order | ||
Danger! | Risk of accidents caused by unintentional vehicle rolling when the engine is started. Risk of injuries by pinching and burns from contact during the starting procedure or with the engine running | Protect the vehicle against unintentional rolling. Use closed and tight-fitting working clothes. Do not touch heated-up or moving parts. | |
5 | Start the engine | ||
6 | With the engine running, check the metering unit (1) for tightness |
Exhaust aftertreatment