ar1415g6302f

Remove/install engine brake valve fitting

Typ ar · téma 14.15 · verze 0101 · 2012-02-16

Platí pro: ENGINES 926.969

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 14 Sběrné výfukové potrubí, motorová brzda, zařízení pro snížení obsahu škodlivin ve výfukových plynech › 14.15 Motorová brzda

EinPAS 21 Brzdy/podtlakový systém/vzduchotlaké zařízení › 21.20 Motorová brzda › 21.20.35 Těleso škrticí klapky/válec

Platí také pro motory/převodovky: 926 969

AR14.15-G-6302F

Remove/install engine brake valve fitting

15.2.12

ENGINES 926.969

Remove/install engine brake valve fitting

W14.15-1014-06

1 Exhaust pipe

2 Clip

3 Engine brake cylinder

4 Turbocharger

5 Compressed-air line

6 Heat shield

7 Engine brake flap connection

Remove/install

1

Switch off ignition

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

2

Disconnecting the battery

See information from vehicle manufacturer.

Notes on battery

AH54.10-P-0001-01A

3

Open engine hood

See information from vehicle manufacturer.

4

Remove clamp (2) on exhaust pipe (1)

Installation: Clean sealing surfaces and check clamp (2) for wear, replace clamp (2) if necessary.

5

Loosen all clamps on exhaust pipe (1) up to the rear muffler

6

Remove heat shield (6)

7

Detach compressed air line (5) at engine brake cylinder (3)

8

Remove engine brake flap fitting (7)

Installation: Clean sealing surfaces.

*BA14.10-N-1002-01L

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

9

Inspect engine brake flap fitting (7) for wear

If worn:

Repair engine brake flap fitting (7).

AR14.15-G-5810BB

10

Install in the reverse order

Exhaust manifold

Number

Designation

Engine
900.91/92, 902.92/93, 904.92/95, 906.935/95, 924.91/92/93, 926.96

BA14.10-N-1002-01L

Nut, engine brake flap fitting to turbocharger

M8

Nm

30

M10

Nm

50

Odkazované dokumenty