S09.20-2001-09
1 Oil filler connecton
2 Suction pipe
3 Mix chamber
4 Engine vent pipe
5 Pedal position sensor acceleration cable (Code G40)
6 Gasket
7 Dipstick guide tube
8 Suspension ring
9 Allen screw
10 Acceleration cable
11 Fastening
12 Vacuum pipe (Engine 601.970)
13 Combined screw
14 Tempomat connection bar (Code MD9)
15 Tempomat return lever (Code MD9)
16 Injection pump connection bar
17 Control lever
| Removing, installing | ||
1 | Remove the oil filler connection (1) | ||
2 | Remove the mix chamber (3) | ||
3 | Remove the engine vent pipe (4) | Engine 601.942 | |
4 | Remove the suction pipe (2) the fastening (11) of the injection pipes | Do not deform the injection pipes! | |
| |||
5 | Disconnect the vacuum pipe (12) | Engine 601.970 | |
6 | Unhook the acceleration cable (10) | ||
7 | Unhook the acceleration cable from the pedal position sensor (5) | with automatic gearbox (Code G40) | |
8 | Unhook the injection pump connection bar (16) in the control lever (17) | ||
9 | Unhook the Tempomat connection bar (14) in the Tempomat return lever (15) | with Tempomat (Code MD9) | |
10 | Remove the dipstick guide tube (7) from the suction pipe (2) | ||
11 | Remove the suction pipe (2) with the gasket (6) and the suspension ring (8) | | |
Installation: Clean the contact surfaces, replace the gasket (6) | |||
12 | Remove the control components from the suction pipe | When replacing the suction pipe | |
13 | Installation in reverse order | ||
14 | Adjust the engine control |
Diesel injection system in general
Number | Designation | Engine 601.942 601.970 | |
BA07.11-N-1003-01A | Injection pipe fastener in suction pipe | Nm | 10 |
Suction pipe, suction pipe preheating