ar0715t1628bb

Removing/installing a MR/PLD control unit

Typ ar · téma 07.15 · verze 0105 · 2012-02-16

Platí pro: ENGINE 457.944 in MODELS NMB613.358 /367 /388

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 07 Příprava směsi › 07.15 Systém vstřikování paliva vznětového motoru (PLD), regulace motoru (MR) — Řada 613 (modely 358, 367, 388)

EinPAS 15 Motor › 15.45 Management motoru › 15.45.11 Řídicí jednotka/relé — Řada 613 (modely 358, 367, 388)

Platí také pro motory/převodovky: 457 944

AR07.15-T-1628BB

Removing/installing a MR/PLD control unit

14.2.12

ENGINE 457.944 in MODELS NMB613.358 /367 /388

Removing/installing a MR/PLD control unit

T07.15-0001-06

Shown on model 613.358/388

1 Electrical connector for the engine wiring harness

2 Electrical connector of the vehicle wiring harness

3 Bolt

4 Rubber damper

5 Ground bow

A6 MR/PLD control unit

Removing/installing

1

Detach lower engine compartment paneling

For model 613.358/388

AR61.20-T-1105B

in case of MODEL 613.367

AR61.20-T-1105CA

Danger!

Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries

No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and safety glasses. Only pour battery acid into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

2

Disconnect battery

For model 613.358/388

AR54.18-T-0002BA

in case of MODEL 613.367

AR54.18-T-0002CB

3

Remove fuel heat exchanger

The fuel lines must not be detached.

AR47.21-T-5621BB

4

Separate the electrical connector of the vehicle wiring harness (2) at the MR/PLD control unit (A6)

Release the electrical connector of the vehicle wiring harness (2) by pressing the lock.

Installation: Secure the electrical connector of the vehicle wiring harness (2) with the lock.

5

Separate the Electrical connector for the engine wiring harness (1) at the MR/PLD control unit (A6)

Release the Electrical connector for the engine wiring harness (1) by swiveling the lock.

Installation: Secure the Electrical connector for the engine wiring harness (1) by swiveling the lock.

6

Unscrew bolts (3) and take off MR/PLD control unit (A6) together with rubber shock absorber (4) and ground clamp (5)

Installation: If the MR/PLD control unit (A6) has been replaced, then if required, enter a new data record in the MR/PLD control unit (A6) with the diagnostic tool.

*BA07.15-N-1002-01C

7

Install in reverse order

Diesel injection system with unit pumps (MR/PLD)

Number

Designation

Engine 457.9

BA07.15-N-1002-01C

Bolt for MR/PLD control unit on crankcase

Nm

12

Odkazované dokumenty