ar0708p7008olf

Remove/install injection system control unit

Typ ar · téma 07.08 · verze 0100 · 2014-04-11

Platí pro: ENGINE 651 in MODEL 222

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 07 Příprava směsi › 07.08 Řídicí jednotky — Řada 222 · Řada 651

EinPAS 15 Motor › 15.45 Management motoru › 15.45.11 Řídicí jednotka/relé — Řada 222 · Řada 651

AR07.08-P-7008OLF

Remove/install injection system control unit

26.03.2014

ENGINE

651 in MODEL 222

Remove/install injection system control unit

1

Electrical connections

2

Electrical wiring harnesses

3

Screw/bolts

N3/9

CDI control unit

P07.08-2235-11

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Connect diagnostic system and read out variant coding of the CDI control unit (N3/9)

When replacing the CDI control unit (N3/9)

AD00.00-P-2000-04B

2

Detach ground line from on-board electrical system battery

AR54.10-P-0003LF

Notes on battery

AH54.10-P-0001-01A

3

Remove engine cover

Installation: Ensure correct seating.

4

Unhook electrical wiring harness (2) on air filter housing (arrows)

5

Unlock and disconnect electrical connections (1) and detach from CDI control unit (N3/9)

6

Remove screw/bolt (3)

7

Remove CDI control unit (N3/9)

Installation: Replace seal between CDI control unit (N3/9) and air filter housing.

8

Install in the reverse order

9

Perform commissioning of the CDI control unit (N3/9)

When replacing the CDI control unit (N3/9)

AD00.00-P-2000-04B

Danger !

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

10

Carry out an engine test run

Odkazované dokumenty