000 589 13 99 00
Blade holder with clamping pliers
Wiring harness repair kit, basic
New passenger vehicle wiring harness repair kit
RK 2.5 blade solder contact
220 589 04 99 00
220 589 01 99 50
220 589 01 99 53
P54.18-2542-01
Unfasten secondary release on version with slide
1 Insert a suitable tool under the slide valve cap (1) and press the slide valve out of the last detent in direction shown by arrow.
P54.18-2543-04
Unfasten secondary release on version with securing clip
2 Using a suitable tool, pry up the side tabs of the retaining clamp (1).
3 Open the retaining clamp (1).
P54.18-2544-06
Unpin contact from the connector
4 Insert blade holder with clamping pliers and RK 2.5 solder contact blade from rear side into cable duct of connector.
Align sleeve of RK 2.5 solder contact blade to spring shackle (1) of connector housing.
This step presses on the spring shackle (1) of the connector.
5 Remove contact pin together with blade holder with clamping pliers and RK 2.5 solder contact blade from connector by gently pulling towards rear.