Remove contacts from 2.5 solder contact plug round plug contact

Type ar · topic 00.19 · version 0109 · 2009-06-23

Applies to: MODEL all

Where it sits

Function group 0 Overall › 00 Overall vehicle › 00.19 Electrical Vehicle, complete network — Series 900 (models 9**) · Series 902 (models 9**) · Series 904 (models 918, 919, 924, 925, 938, 943, 957) · Series 906 (models 917, 918, 924, 953)

EinPAS 25 On-board/network/multifunction › 25.25 Main wiring harness › 25.25.1 Basic information — Series 900 (models 9**) · Series 902 (models 9**) · Series 904 (models 918, 919, 924, 925, 938, 943, 957) · Series 906 (models 917, 918, 924, 953)

Also applies to engines/gearboxes: 139 ***, 254 ***, 256 ***, 272 ***, 276 ***, 282 ***, 457 9**, 541 9**, 542 9**, 608 ***, 700 4**, 700 420, 700 421, 700 422, 700 423, 715 3**, 715 5**, 722 6**, 722 9**, 724 ***, 724 0**, 724 033, 724 044, 724 045, 724 1**, 724 103, 724 114, 724 115, 724 120, 725 ***, 725 0**, 725 035, 725 037, 725 038, 725 085, 725 1**, 739 390, 739 391, 739 395, 739 396, 739 397, 739 398, 739 399, 740 698, 743 3**, 743 4**, 743 498, 746 971, 924 9**, 924 910, 925 9**, 926 9**

AR00.19-P-0120-18A

Remove contacts from 2.5 solder contact plug round plug contact

000 589 13 99 00

Blade holder with clamping pliers

Wiring harness repair kit, basic

New passenger vehicle wiring harness repair kit

RK 2.5 blade solder contact

220 589 04 99 00

220 589 01 99 50

220 589 01 99 53

P54.18-2542-01

Unfasten secondary release on version with slide

1 Insert a suitable tool under the slide valve cap (1) and press the slide valve out of the last detent in direction shown by arrow.

P54.18-2543-04

Unfasten secondary release on version with securing clip

2 Using a suitable tool, pry up the side tabs of the retaining clamp (1).

3 Open the retaining clamp (1).

P54.18-2544-06

Unpin contact from the connector

4 Insert blade holder with  clamping pliers and  RK 2.5 solder contact blade from rear side into cable duct of connector.

 Align sleeve of  RK 2.5 solder contact blade to spring shackle (1) of connector housing.
This step presses on the spring shackle (1) of the connector.

5 Remove contact pin together with blade holder with  clamping pliers and  RK 2.5 solder contact blade from connector by gently pulling towards rear.