Retrofit roof rack mounting

AN77.50-P-1000V

18.2.04

MODEL 171.4## (except 171.473) 1#

P77.50-2175-04

Shown on right side of vehicle

1 Outer A-pillar paneling

2 Blind rivet nut

P77.50-2179-01

1 Outer A-pillar paneling

8 Longitudinal marking

		On vehicles up to VIN 009766 SI65.00-P-0001V Observe and perform
		There are two variously long outer A-pillar panelings (1) due to production tolerances. Both lengths are included in each installation kitFirst determine length required for outer A-pillar paneling (1) The two remaining outer A-pillar panelings (1) are not required
1	Completely open Vario roof with Vario roof actuation switch	 Actuate Vario roof, see operating instructions
2	Press upper rubber cover on outer A-pillar paneling (1) to side and read off longitudinal marking (8)	 Meaning of longitudinal marking (8):  "K" = short  "L" = long
3	Paint determined outer A-pillar paneling (1) to match color of the vehicle
	Remove
4	Remove outer A-pillar paneling (1)	 Always replace all clips
			AR88.80-P-8500V
5	Remove trunk lid seal
			AR88.50-P-5010V
	Install
6	Retrofit A-pillar roof rack mounting		AN77.50-P-1000-01V
7	Install new outer A-pillar paneling (1)
			AR88.80-P-8500V
8	Install rear roof rack mounting		AN77.50-P-1000-02V
		Adjustment value for jigging blind rivet nut for roof rack mounting	*BE65.00-P-1001-01A
		FireBird® blind rivet tool	*WE58.40-Z-1003-14A
9	Install new trunk lid seal
			AR88.50-P-5010V
10	Enter special equipment in the vehicle data card and in the vehicle's online data card	Code (726) Roof rack mounting

Adjustment value

Number	Designation		Model 171.4


BE65.00-P-1001-01A	Adjustment value for jigging blind rivet nut for roof rack mounting	mm	3.5 (+0.1)

Workshop equipment

WE58.40-Z-1003-14A

Blind rivet tool

Parts ordering notes

Part no.	Designation	Quantity
Design group 99 (see EPC)	Roof rack mounting	1