ad0761p400004a

Fault code description - ME-SFI - coolant temperature sensor

Typ ad · téma 07.61 · verze 0104 · 2003-06-06

Platí pro: ENGINES 112.910, 112.911 up to 31.5.00, 112.920, 112.921 up to 31.5.00, 112.923, 112.940 /941 /942 up to 31.5.00, 112.943 ENGINES 113.940 /942 /943 up to 31.5.00, 113.961 ENGINES 112.945, 113.962 up to 30.11.00 in MODEL 463

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 07 Příprava směsi › 07.61 Systém vstřikování paliva a zapalování zážehového motoru ME — Řada 463

EinPAS 15 Motor › 15.25 Chladicí systém motoru › 15.25.1 Základní informace — Řada 463

Platí také pro motory/převodovky: 112 910, 112 911, 112 920, 112 921, 112 923, 112 940, 112 941, 112 942, 112 943, 112 945, 113 940, 113 942, 113 943, 113 961, 113 962

AD07.61-P-4000-04A

Fault code description - ME-SFI - coolant temperature sensor

1

Fault code

2

Fault storage

Activation of malfunction indicator lamp for engine diagnosis (EURO3/4)

or CHECK ENGINE (MIL)

after the end of the test period and faults

after two successive driving cycles with faults

3

Frequency of the test

continuous

4

Checked signal or status

Limits for coolant temperature/plausibility

5

Fault setting conditions

Lower limit

Upper limit

Plausibility

Fault, if the resistance is greater than approx. 80 kΩ (approx. -39 °C)

Fault, if the resistance is less than approx. 45 Ω (approx. +170 °C)

The increase in temperature after a cold start is compared to a stored temperature model (characteristic). Depending on the start temperature and the engine speed, at least +15 °C must be reached after approx. 120 - 1200 s.

6

In the event of a fault, driving continues at a substitute value from the temperature model. If the signal becomes plausible again, the system changes over to the signal from the coolant temperature sensor.