Remove/install bracket for lift bellows of additional axle

AR35.50-B-0460A

Remove/install bracket for lift bellows of additional axle

27.02.2018

Model

979.096/098 with rear axle 749.117

4

Auxiliary axle

10

Bracket for lift bellows

7

Regulation nuts

C

Adjusting measurement (with depressurized shaft)

9

Self-locking nuts

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A



Remove

1

Remove the brackets for lift bellows (10) self-locking nuts (9)


Do not move the adjusting nuts (7)
This position determination can help adjusting the height of the clips.



Check

2

Check the conditions of the brackets for lift bellows (10) and adjusting nuts (7)

 Always replace the self-locking nuts (10).

In case the brackets for lift bellows (10) and the adjusting nuts (7) are in good conditions and are reused:



Do not move the adjusting nuts (7) as they will be the basis for adjusting the measure (C).



Install

3

Install the adjusting nuts (7) to the brackets for lift bellows (10)

If the components are new

4

Install the brackets for lift bellows (10) securing with adjusting nuts (9)

 Do not apply the prescribed torque.

5

Adjust measure "C" between the brackets for lift bellows (10) and the auxiliary axle (4)

AR35.50-B-3593-01A

Adjustment measure between the bellows arch and the auxiliary shaft

*BE35.50-B-1001-04A

6

Apply the tightening torque to the fixing nuts (9)

 Upper nut for locking the bellows arch

*BA35.50-B-1001-04A

Measurement of the clearance between the clamp and the auxiliary shaft

Number

Designation

Rear axle 749.117/118

BE35.50-B-1001-04A

Adjustment measure between the bellows arch and the auxiliary shaft

Vehicle empty without load

mm

20

Vehicle without body

mm

10

 Fixture of the auxiliary shaft hanger

Number

Designation

Rear axle 749.117/118

BA35.50-B-1001-04A

Upper nut for locking the bellows arch

M22x1.5

Nm

260 ... 300