si3525g0001a

Service information: Vent lines at hub reduction axle

Loại si · chủ đề 35.25 · phiên bản 0100 · 2003-06-17

Áp dụng cho: MODEL 427 with FRONT AXLE 737.42 with REAR AXLE 747.42 MODEL 437 with FRONT AXLE 737.2 /42 with REAR AXLE 747.2 /42

Không có bằng “vi”; đang hiển thị bằng tiếng Anh.

Vị trí

Nhóm chức năng 2 Chassis › 35 Rear axle › 35.25 Axle housing — Dòng 427 · Dòng 437

EinPAS 17 Drivetrain/axle › 17.51 Rear axle › 17.51.60 Hub reduction gear/planetary hub reduction drive — Dòng 427 · Dòng 437

EinPAS 45 Data/information › 45.20 Information/measures › 45.20.20 Service information — Dòng 427 · Dòng 437

Cũng áp dụng cho động cơ/hộp số: 737 2**, 737 42*, 747 2**, 747 42*

SI35.25-G-0001A

Service information: Vent lines at hub reduction axle

27.10.00

MODEL 427 with FRONT AXLE 737.42 with REAR AXLE 747.42

MODEL 437 with FRONT AXLE 737.2 /42 with REAR AXLE 747.2 /42

Modification notes

27.10.00

Supersedes STIN 35.10G014 dated 26.10.2000

SI file 35/54

Service information: Vent lines at hub reduction axle

G35.10-3110-02

Modified routing at rear axle, front axle by analogy.

The routing of the vent line at the hub reduction axle has been modified in the case of the axle model designations listed above. The vent lines are connected to each hub reduction axle, instead of to the rear vent hole at the front hole.

The production breakpoint was implemented in the case axle model designation 737/747.2 with VIN437105-1W-195308 and in the case of axle model designation 737/747.42 with VIN427115-1W-196140.

If a complaint about "Oil escaping through vent" is received, the line can also be re-routed on preceding VINs.