AR43.40-D-1003A | Remove/install retarder step switch | 22.9.10 |
MODEL 906 with CODE (PB2) Mastercode retarder VMC
D43.40-0043-08
1 Rubber bellows
2 Fuse
3 Selector lever
S191/1 Selector lever retarder switch
4 Nut
5 Catch
| Remove/install | ||
1 | Remove transmitter key from electronic ignition lock control unit | ||
2 | Remove side air vent | ||
3 | Pull rubber bellows (1) to rear | Installation: Latch rubber bellows (1) into catch (5). | |
4 | Carefully pull locking clip (2) upwards | Installation: The locking clip (2) must audibly latch into place. | |
5 | Remove selector lever (3) | Note installation position of selector lever (3), mark if necessary. | |
6 | Unscrew nut (4) | ||
7 | Remove catch (5) | ||
8 | Detach wiring harness for retarder selector lever (S191/1) from connector | ||
9 | Remove retarder selector lever switch (S191/1) from rear and out of dashboard | ||
10 | Install in the reverse order |