Adjusting sliding door

AR72.16-L-1023VA

Adjusting sliding door

18.2.02

Adjusting



Notes on carriage and guide rails for sliding doors

Model 414

AH72.16-N-0001-01VA

1

Unclip bottom cover (8) from sliding door paneling.

2

Unclip center cover (9) from sliding door paneling

3

Remove guide wedges with subsurfaces (10).

4

Loosen bolts (3, 5, 7) and adjust gaps (C, D, E, F) by moving the sliding door (1)

The center of the carriage (4) must be adjusted parallel with the center of the guide rail.

 Adjust carriage (2, 4, 6) to sliding door (1).

Dimension "C": Gap for sliding door to front door

Dimension "D": Gap for sliding door to outer rocker panel

Dimension "E": Gap for sliding door to rear fender

Dimension "F": Gap for sliding door to roof edge

*BE60.00-P-1010-01A

Feeler gauge

*129589032100

Setting gage

*414589002100

5

Tighten bolts (3, 5, 7)



*BA72.16-P-1002-01A

6

Loosen bolts (3, 7) and adjust a projection of 1 mm in the Y direction (b) at the front edge of the sliding door (1) above the driver door

 Maintain remaining door adjustments.

7

Tighten bolts (3, 7).



*BA72.16-P-1002-01A

8

Attach bolts (11) and close door.

The guide wedges (10) slide into the zero position in the sliders.

9

Move the guide wedges parallel with the liners (10) in the Y direction (b)

 Vehicles up to vehicle identification number 226 866

Position upper guide wedge 2 mm outwards and lower guide wedge 1.5 mm outwards. The edge of the sliding door must be set back by 0 to 1 mm behind the driver's door in the Y direction (b).

10

Tighten bolts (11)

 Vehicles up to vehicle identification number 226 866

Ensure that guide wedges (10) remain parallel to the zero position when moved.

11

Adjust the rear installation depth of the sliding door by adjusting the striker in direction Y (b)

 The rear edge of the sliding door must project by 0 to 1 mm beyond the side wall in the Y direction (b).



Inspect

12

Check gaps all the way around the sliding door (1) and ensure that center carriage (4) is positioned parallel.

Setting gage

*414589002100

13

Check sliding door for easy motion; if necessary, repeat adjustment.

Number

Designation

Model
414.700

BE60.00-P-1010-01A

Gap size

Sliding door to front door

Dimension "C"

mm

5.0 (0.5)

Sliding door to outer sill cover

Dimension
" D"

mm

5.0 (0.5)

Sliding door to rear fender

Dimension
" E"

mm

8.0 (0.5)

Sliding door to roof edge

Dimension
" F"

mm

5.0 (0.5)

Fig. see

-

Number

Designation

Model
414.700

BA72.16-P-1002-01A

Bolt, sliding base to sliding door

NM

25