AR72.10-W-2010-02A | Adjust travel at actuating cylinder | ||
Danger! | Risk of injury from pinching and crushing when working on the folding door and the folding door control system | When working on the folding door or folding door control, relieve pressure from system with emergency lever (off position). |
Modification notes
Check
1 Check whether the actuating cylinder closes the folding door completely.
The seal on the rear door wing must make firm contact to the seal of the door frame and the folding door should not move.
2 Check whether the actuating cylinder opens the folding door completely.
Both door wings must make contact with one another and the guide roller in the rear door wing must make contact with the stop buffer.
W72.40-1002-12
Adjust
3 Unscrew counternut (2).
4 Adjust operation path of the actuating cylinder by turning piston rod (3).
If, for example, the piston rod (3) is turned further into the joint end, the opening width of the folding is reduced and the contact pressure on the door frame increases when the folding door is closed.
5 If necessary, additionally adjust stop buffer (6).
For this purpose loosen jam nut (4), adjust stop buffer (6) by turning square (5) and tighten jam nut (4)
6 Tighten counternut (2) on knuckle (1).
Atıfta bulunulan belgeler
- as7200z000101a Katlanır kapı ve katlanır kapı kumandasında yapılan çalışmalarda sıkışma veya ezilme nedeniyle yaralanma tehlikesi