Carry out teach-in process for activation of oil level sensor

Tür ar · konu 55.30 · sürüm 0101 · 2010-12-09

Geçerli olduğu: MODEL 405.10 /12 /20 /22 with CODE (H63) Power hydraulics, closed circuit (125 l/min. 300 bar) with CODE (H64) Power hydraulics, open circuit (90 l/min. 280 bar) with CODE (H65) Power hydraulics with adjusting pump, closed circuit (125 l/min. 300 bar), open circuit (90 l/min. 280 bar)

“tr” dilinde mevcut değil; İngilizce gösteriliyor.

Konumu

Fonksiyon grubu 2 Şasi › 55 Yardımcı güç çıkışı , Hidrolik ve mafsal sistemleri › 55.30 Hidrolik tahrik, Hidrolik pompa — Seri 405 (modeller 10*, 12*, 20*, 22*)

EinPAS 35 Kaporta/Şasi/Ek parçalar › 35.70 Kaldırma ekipmanı/Hidrolik sistemi › 35.70.12 Sensör/Şalter/Kablo demeti — Seri 405 (modeller 10*, 12*, 20*, 22*)

AR55.30-G-0004-03B

Carry out teach-in process for activation of oil level sensor

G54.25-3462-71

1 Press buttons (1, 2) at the same time and keep pressed, switch on ignition.

 The buttons (1, 2) have to be pressed and held throughout the entire teach-in process. After switching on the ignition the LEDs on buttons (3, 4, 5) light up for approx. 2 s. The LEDs on buttons (1, 2) then light up for approx. 2 s. Only release the buttons (1, 2) once the LEDs on the buttons (1, 2) have gone out again.

2 Switch off ignition.

3 Switch on ignition.

4 Press button (6) and observe bargraph (7).

 A brief lighting of the LEDs for the oil level confirms that parameterization was successful. Otherwise the operation steps 1 to 4 must be repeated.