Remove/install ball head · ar4640d7242b · Mercedes-Benz WIS

AR46.40-D-7242B

Remove/install ball head

24.4.07

MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7

MODEL 903.61 /66 /67, 904.61 /66 with CODE (ZU7) National version for Canada

MODEL 903.61 /66 /67, 904.61 /66 with CODE (ZU8) National version for USA

MODEL 903.61 /62 /66 /67, 904.61 /62 /66 with CODE (ZU9) National version for Mexico

D46.40-0003-06

1 Nut

2 Ball head

3 Lock nut

4 Tie rod

 Puller

Modification notes

24.4.07

Lock nut at ball head

	Remove
1	Jack up vehicle.	 Secure vehicle to prevent it rolling away.
2	Remove wheels.
3	Unscrew nut (1).
4	Slacken lock nut (3).
5	Pull ball head (2) off steering arm.		*601589043300
6	Unscrew ball head (2) from tie rod (4).
	Install
7	Screw ball head (2) onto tie rod (4).
8	Press ball head (2) on tie rod (4) firmly into socket.	 Before installing, clean grease off socket joint and clean contact surfaces on steering arm (arrows).
9	Tighten nut (1) for ball head.		*BA46.40-N-1001-06D
10	Install wheels.		*BA40.10-N-1001-01A
11	Lower vehicle.
12	Adjusting toe		AR40.20-D-0200D
		 To adjust the toe: Undo bellows on tie rods and then refasten.	AR46.40-D-7200-01A
13	Tighten lock nut (3).		*BA46.40-N-1003-06D

 Wheels

Number	Designation		Model WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD6, XD7, YD1, YD2, YD3, YD6, YD7	Model XD4, XD5, XD8, YD5, YD8, YD9, XD9, YD4


BA40.10-N-1001-01A	Wheel bolt or lug nut	Nm	240 (+10)	190 (+20)

 Steering linkage

Number	Designation				Model 690.6, 901, 902, 903, 904, 905	Model WD1/WD2/ WD3/WD6/ WD7/XD1/ XD2/XD3/ XD4/XD5/ XD6/XD7/ YD1/YD2/ YD3/YD4/ YD5/YD6/ YD7


BA46.40-N-1001-06D	Nut on ball joint	M141.5	1st step	Nm	-	-
			2nd stage	°	-	-
		M161.5		Nm	130	130
BA46.40-N-1003-06D	Lock nut at ball head			Nm	65	65

601 589 04 33 00

Puller