ar3530b430201a

Adjust preload of tapered roller bearings

Tür ar · konu 35.30 · sürüm 0101 · 2019-02-15

Geçerli olduğu: Rear axle 746.27/97 in model 382.171/177/180/181/185/188/189 Rear axle 746.960 Rear axle 746.961/964 in model 693.184/191/195, 695.043 Rear axle 746.962 in model 386.014 Rear axle 746.964 in model 693.144 Rear axle 746.966 in model 693.128, 695.014 Rear axle 746.974 in model 634.081 Rear axle 772 in model 695.302

“tr” dilinde mevcut değil; İngilizce gösteriliyor.

Konumu

Fonksiyon grubu 2 Şasi › 35 Arka aks › 35.30 Tahrik, Tahrik milleri — Seri 382 (modeller 171, 177, 180, 181, 185, 188, 189) · Seri 386 (modeller 014) · Seri 634 (modeller 081) · Seri 693 (modeller 128, 144, 184, 191, 195) · Seri 695 (modeller 014, 043, 302)

EinPAS 17 Tahrik aksamı/Aks › 17.51 Arka aks › 17.51.65 Arka aks dişli kutusu/aks tahrik çıkışlı diferansiyeli — Seri 382 (modeller 171, 177, 180, 181, 185, 188, 189) · Seri 386 (modeller 014) · Seri 634 (modeller 081) · Seri 693 (modeller 128, 144, 184, 191, 195) · Seri 695 (modeller 014, 043, 302)

Motorlar/şanzımanlar için de geçerli: 746 27*, 746 960, 746 961, 746 962, 746 964, 746 966, 746 97*, 746 974, 772 ***

AR35.30-B-4302-01A

Adjust preload of tapered roller bearings

Rear axle

746.27/97 in model 382.171/177/180/181/185/188/189

Rear axle

746.960

Rear axle

746.961/964 in model 693.184/191/195, 695.043

Rear axle

746.962 in model 386.014

Rear axle

746.964 in model 693.144

Rear axle

746.966 in model 693.128, 695.014

Rear axle

746.974 in model 634.081

Rear axle

772 in model 695.302

Adjust preload of tapered roller bearings

055 589 05 21 00

Adjusting device

Adjust preload of tapered roller bearings

1

Gradually tighten the ring (1) just enough to clear the gap between the sprocket and pinion teeth. Then loosen it from 3 to 4 castles.


Make sure that one of the ring holes (1) is aligned with the locking pin of the locking plate.


B35.30-0051-01

Adjust preload of tapered roller bearings

2

Gradually tighten the ring (2) using the pin wrench (3) until the clearance of the bearings is eliminated. From this point tighten it more, to get the necessary preload.
For NEW bearings = tighten from 2 to 3 castles.
For USED bearings = tighten from 1 to 2 castles.


B35.30-0052-01