Remove/install pump module intake filter

AR14.40-B-2040TB

12.02.16

Cumbustion engine 457 with Vehicle 958.434, 958.443, 958.441, 958.444, 958.453, 958.452, 958.454

Cumbustion engine 457.910 with Vehicle 958.431, 958.433, 958.451, 958.471, 958.472, 958.478

Cumbustion engine 457.911 with Vehicle 695.053, 695.023

Cumbustion engine 460.984 with Vehicle 934.### #R, 934.### #S

Remove/install pump module intake filter

W14.40-1427-09

1 Housing cover

2 Electric connector

3 AdBlue pipe

4 Piping/ wiring harness

5 Open end wrench

6 Open end wrench

7 Pump module

8 Self-locking screw (M440)

9 Intake filter

10 Seal

11 AdBlue inlet connection

12 Filter screen on inlet connection

	Removing and installing
Danger!	Risk of burns and scalding while working on AdBlue pipes and on components connected to them. Risk of injury on skin and eyes at contact with AdBlue. Risk of poisoning from swallowing AdBlue	Only catch AdBlue in appropriate containers. Only start working on the exhaust gas after-treatment system after relieving the pressure.	AS14.40-B-0001-01A
	Indications for applications, material properties and handling AdBlue		AH14.40-B-0001-01A
1	Switch-off the ignition
2	Detach the electric connector (2) on the pump module (7)	 Protect the electric connector (2) and the electric connection on the pump module (7) with a plastic film or something similar to avoid AdBlue drainage.
		 The electric connector (2) and the electric connection should not get in contact with AdBlue, otherwise damage may occur in the electric wiring harness and in the SCR module SCR
3	Check the electric wiring harness for corrosion		AR14.40-B-2033TA
4	Remove the AdBlue piping (3) on the AdBlue inlet piping (11), and plug with the seal (10)	 The seal (10) must be ready at hand to avoid excessive AdBlue running off.
	Seal for the AdBlue intake pipe		WF58.50-B-1440-05A
5	Remove the housing cover (1)	 Only on vehicles with pump module (7) on which the filter screen housing hexagon in inlet (12) is behind the housing (1) cover.	*BA14.40-B-1047-02C
6	Remove the AdBlue inlet connection (11) on the filter strainer (12)	 To remove the AdBlue inlet connection (11), secure with an open end wrench (6), by the filter strainer (12).	*BA14.40-B-1045-02C
7	Remove the intake filter (9) from the filter strainer (12)	 The intake filter (9) can be pulled with a self-locking screw (8).
8	Install in reverse order

Exhaust aftertreatment

Número	Denominação		Engine 457.9 with Code MS5


BA14.40-B-1045-02C	AdBlue inlet neck on screen located at the intake tube edge	Nm	15
BA14.40-B-1047-02C	Pump module housing cover	Nm	8

Atıfta bulunulan belgeler