L09.20-0004-09
1 Intake module
2 Bolts
3 Suspension eye
4 Torx bolts
5 Shaped rubber gaskets
6 Mixing chamber
13 Vacuum hose
14 Locking lever
15 Vacuum line (brake booster)
B28 Charge pressure sensor
7 Air intake duct
8 Oil filler neck
9 Air intake pipe
10 Oil separator
11 Fuel full-flow filter
12 Torx bolt
| Remove/install | ||
1 | Remove air intake line (7) | ||
2 | Remove mixing chamber (6) | ||
3 | Detach fuel full-flow filter (11) at the intake module (1) and place to the side with fuel lines connected | | |
4 | Remove oil separator (10) | ||
5 | Detach vacuum line (15) at the retaining clamps at the intake module (1) | ||
6 | Detach vacuum hose (13) at charge pressure sensor (B28) | ||
7 | Detach oil filler neck (8) at the intake module (1) | | |
8 | Unscrew bolts (2) of heat shield | ||
9 | Unscrew torx bolts (4) at intake module (1) | Take off suspension eye (3). Pay attention to installation position of dipstick guide tube and various fixtures for wiring harnesses and lines which are attached together to the intake module. | |
| |||
10 | Detach intake module (1) at air intake pipe (9) and remove | Swivel locking lever (14) at intake module (1) first of all to the side, and then down (arrows). | |
11 | Take intake module (1) off the cylinder head | Installation: Replace shaped rubber gaskets (5) (8 x). | |
12 | Install in the reverse order |
Intake manifold
Number | Designation | Engine 668.914 | |
BA09.20-P-1005-01F | Bolt of oil filler neck to intake module | Nm | 9 |
BA09.20-P-1006-01F | Bolt of intake module to cylinder head | Nm | 14 |
Fuel filter
Atıfta bulunulan belgeler
- ar0120p9750gd Yağ ayırıcının sökülmesi, takılması
- ar0920l1330va