Remove/install belt pulley/vibration damper

AR03.30-G-1600MT

10.1.07

MODEL 000.001 with ENGINE 444.901
Euro 1

MODEL 000.001 with ENGINE 444.901
Euro 2

MODEL 000.001 with ENGINE 447.903
Euro 2

G03.30-3134-06

Shown on engine 447.903

1 Belt pulley or vibration damper

2 Bolt

3 Splash ring

 	Remove/install
1	Remove hub on belt pulley or vibration damper (1)	 If hub is present.
		 See MTU workshop manual.
2	Remove coolant pump V-belt	Engine 447.903	AR13.21-G-0180MT
		Engine 444.901	AR13.21-G-0180MTA
3	Install turning device on clutch housing	 To counterhold crankshaft.	AR03.30-G-1600-03MT
			*BA01.60-N-1003-01L
			*000589642100
			*407589006300
4	Remove bolts (2) for attaching belt pulley or vibration damper (1) to crankshaft	 Counterhold crankshaft in doing so using the turning device.
			*BA03.30-N-1001-01T
			*000589392100
			*407589006300
5	Remove belt pulley or vibration damper (1)
6	Remove slinger (3)	 Mark installed position.
		 Installation: Observe identification to determine the installation position.
7	Clean all parts and check for wear.	 Replace, if necessary.
8	Install in the reverse order

 Timing case

Number	Designation		Engine 447.903	Engine 444.901


BA01.60-N-1003-01L	Bolt, sealing cover to timing case	Nm	25	25

 Flywheel, drive plate, vibration damper, starter ring gear

Number	Designation		Engine 444.901, 447.903


BA03.30-N-1001-01T	Bolt, vibration damper to crankshaft	Nm	200

000 589 64 21 00

Cranking device

Torque wrench

000 589 39 21 00

407 589 00 63 00