1 | Screw cap |
2 | Seal ring |
3 | Filter Element |
4 | Dirt collecting reservoir |
5 | Fuel filter housing |
N07.57-0226-01
N07.57-0225-01
| Remove | ||
1 | Open the fuel tank cap | To drain the excessive pressure of the fuel reservoir. | |
2 | Install the threaded cap (1) in the fuel filter housing (5) | Remove the threaded cap (1) with the filtering element (3) only after draining the fuel from the fuel filter housing (5). | |
3 | Remove the threaded cap (1) with the filtering element (3) and detach the filtering element (3), by pressing it sideways | Pay attention to prevent foreign bodies from entering fuel filter housing (5). Never use a cloth to clean inside the fuel filter housing (5). | |
4 | Pull the dirt collector (4) by the handles out of the fuel filter housing (5) | Pay attention in order to prevent the deposited dirt from entering the fuel filter housing (5). | |
do not empty the dirt collector (4) in the filter housing (5). | |||
| Clean | ||
5 | Clean the threaded cap (1) and the dirt collector container (4) | ||
| Install | ||
6 | Replace the sealing ring (2) | Grease sealing ring (2) slightly. | |
7 | Install a new filtering element (3) in the threaded cap (1) | ||
8 | Insert the dirt collector (4) in the fuel filter housing (5) | Pay attention to the correct installation position. | |
9 | Install and tighten threaded cap (1) with filtering element (3) | Cover on the fuel filter housing | |
10 | Close the fuel tank cap | ||
11 | Actuate the engine start-up and bleed the fuel system |
| |
Allow the engine to run for approximately 1 minute. The fuel system bleeds automatically. | |||
12 | Check fuel filter housing for tightness (5) | With the engine running. | |
13 | Stop the engine |