Operation no. of the operation texts or standard texts and flat rates | |||||
Category | Op. no. | Operation text | Time | Acc. no. | Code |
L | 02 2894 | Operations: Check crossbar of air suspension | --- | 31 920 63 | VS3LUFTFED |
L | 02 2895 | Operations: Retrofit a cross strut at crossbar of air suspension (after check) | --- | 31 920 63 | VS3LUFTFED |
L | 02 2952 | Operations: Create TIPS case | --- | 31 920 63 | VS3LUFTFED |
D32.22-A021-79
Shown on model 907 |
1 | Weld seam | 2 | Crossmember |
3 | Bolts |
4 | Nut |
5 | Cross strut |
D32.22-A019-12
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on repair work on suspension components | |||
| Check | ||
1 | Check, whether the vehicle is affected by the measure. | Affected vehicles: Retrofit cross strut on cross bridge of air suspension (Code: VS3LUFTFED, Acc. no.: 31 920 63) | |
For authorized MercedesBenz service partners, only the entry in the "Extended VEGA Application" (EVA) system, in the "Current" tab, is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary. | |||
2 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
| |||
3 | Check whether the weld seams (1) at the crossbar (2) are present. | Clean crossbar (2) in area of weld seams (1) before visual check. | |
If one or both weld seams (1) are not present, | |||
| |||
create a TIPS case. | |||
If the weld seams (1) are present, | |||
| |||
continue with operation step 4. | |||
Install cross strut | |||
4 | Remove screw/bolts (3). | Replace screw/bolts (3). | |
5 | Remove nut (4). | For this, counterhold screw of control arm. | |
Install new nut (4) and screw of control arm. | |||
6 | Retrofit cross strut (5). | The cross strut (5) is currently NOT available through the standard logistics process in GLC. Until further notice, the cross strut (5) must be ordered directly from the manufacturer (VB-Airsuspension). The contact person is Mr. Sander Dusseldorp. Purchase order by email to: [email protected]. | |
Only tighten nut (4) lightly by hand. | |||
For this, screw in screws (3) and attach nut (4). | |||
Bolt, strut to cross member | |||
7 | Lower vehicle. | ||
8 | Counterhold nut (4) and tighten screw of control arm. | Screw, control arm to crossmember/rear axle spring |
Compressor, valve unit, air suspension bellows, level sensor, compressed-air reservoir, crossmember |
Number | Designation | Model 907 | Model 907 | |
BA32.22-N-1010-03TS | Bolt, strut to cross member | Nm | 104 | - |