Service Information: Discontinuity of weld stud for turn rate sensor

P60.00-2789-08

Template

A Template contour

B 80 mm

C 250 MM

1 Marking for vehicles as of production 04/2007

2 Marking for vehicles up to production 03/2007

Application

1 Print out template

2 Measure dimension "B" and dimension "C" of printout

3 Determine factor
(e.g. 250 mm  dimension "C" of printout)

4 Copy template with determined factor

 Dimension "B" and dimension "C" must correspond to the dimensions specified under "Template".

The replacement part A 171 610 04 60 "right-hand floor" does not have a threaded stud for attaching the turn rate sensor. In the case of repairing the right-hand floor, threaded studs (M6) must be retrofitted as "weld studs".

 The replacement part A 171 610 06 60 "right-hand floor" can only be installed on vehicles up to production 03/2007.

The replacement part A 171 610 04 60 "right-hand floor" replaces the replacement part A 171 610 06 60 " right-hand floor"

The position of the threaded stud is shown in the template by a circular marking with a cross. In order to transfer the bolt position to the replacement part "right-hand floor", the template should be cut out and attached to the right-hand floor. The bolt position can be transferred by a center punch marking.

For vehicles up to production 03/2007 weld studs must be placed on the markings (2). For vehicles as of production 04/2007 weld studs should be placed on the markings (1).