42 - 0850 Removal and installation of wheel speed sensors on front axle
|
Removal, installation
1 Switch off ignition and detach electrical plug connection in engine compartment.
2 Completely expose connection cable.
D42-0020-13
3 Remove wheel speed sensor from locator bore in steering knuckle.
Note
Each time a wheel speed sensor is dismantled, replace clamping bush and install with an acid- free grease (Molykote 44 Light silicone grease).
D42-0009-13
Installation note
Push wheel speed sensor in as far as the stop in a locator bore. Clearance adjusts itself automatically once the vehicle is driven.
Route connection cable without chafing and tie up properly.
Perform function check.