PE30.35-W-2001-60D | Legend of wiring diagram for drive control (FR) | ENGINE 541.9 in MODEL 950.0/1/2/3, 952.0/1/2/3, 953.1/3, 954.0/1/2, for vehicles up to production date 31.12.99 with BODY 942.899 ENGINE 542.9 in MODEL 950.0/1/2, 952.0/1/2/3, 954.0/1/2, for vehicles up to production date 31.12.99 with BODY 942.899 ENGINE 906.9 in MODEL 950.5/6/, 952.5/6, 953.6, 954.5, for vehicles up to production date 31.12.99 with BODY 940.899 |
Code | Designation | Coordinates |
A3 | FR/FMR control unit | 7A 20A 32A 45A 58A |
A4 | Flame starting system control unit | 56M |
A6 | MR/PLD control unit | 58M |
A7 | Base module | 3M 9M 30M 46M |
B1 | Foot throttle actuator | 38M |
B2 | Clutch travel sensor | 23M |
B3 | Countershaft rpm sensor | 25M |
B4 | Outside temperature sensor | 49M |
B5 | Parking brake switch | 47M |
B6 | Coolant level switch | 51M |
B7 | Air filter monitoring sensor/switch | 53M |
B70 | Through brake pressure switch | 41I |
F2-A7 | Fuse, instrument illumination, tml. 58 (base module) | 30L |
F10-A27 | Automatic engine oil replenishment fuse, circuit 15 (fuse holder A2) | 46H |
F30-A7 | Fuse, MR/PLD, tml. 15 (base module) | 8L |
G2 | Alternator | 4M |
M2 | Automatic engine oil refill | 43L |
P1 | Speedometer/tachograph | 54M |
P2 | Instrument cluster | 5M 6M |
S1 | Drive switch | 2M |
S2 | Engine control/permanent brake operating lever | 17M 35M |
S3 | Splitter switch | 19M |
S4 | Stop lamp switch | 40M |
S7 | Reverse gear switch | 27M |
S8 | Range position switch | 27M |
S9 | Neutral position switch | 28M |
S82 | Engine start/engine stop switch | 31L |
X2.1 | Cab-chassis connector | 3G 4G 20F 21F 22F 23F 24F 25F 26F 26F 27F 28F 29F 50G 51G |
X2.2 | Cab-chassis connector | 57G 57G 58G 59G |
X3.1 | Cab-chassis connector | 12G 13G 14G 48G 49G |
X3.3 | Cab-chassis connector | 41F 41K |
X3.4 | Cab-chassis connector | 42G 43G 43G 44G 45G |
X6.1 | Cab-chassis connector | 47G 48G |
X29 | Transmission connector | 20I 21I 22I 23I 24I 25I 26I 26I 27I 28I 29I |
Y1 | Engine brake 1 solenoid valve | 13M |
Y2 | Engine brake solenoid valve 2 | 15M |
Y29 | Valve block, GS/EPS, solenoid valve MS2 | 20L |
Y30 | Valve block, GS/EPS, solenoid valve MS1 | 22L |
Z1 | CAN star point cab dash support | 60H |
Z2 | Additional cab dash support CAN star point | 62M |
(5) | on ATEGO 18-26t | 6H |
(9) | on ACTROS | 5H |
(14) | Analog | 51C |
(18) | Constant throttle and brake flaps actuation | 14C |
(19) | Oil refilling and reservoir fill level detection actuation | 43C |
(35) | Reversing/stop lamp actuation | 11C |
(53) | Engine CAN bus interface | 58C |
(81) | Rpm switch | 16C |
(94) | Electronic part | 8C |
(103) | not with BS/EPB | 41M |
(104) | not with GS/EPS | 21M |
(135) | Alternator pre-excitation and D+ recognition | 3C |
(137) | only with transmissions without GS/EPS | 24C |
(138) | In vehicles subject to GGVS | 8H |
(139) | In vehicles not subject to GGVS | 9H |
(173) | Clutch protection valve | 24C |
(174) | Clutch travel detection and splitter gearshift | 22C |
(187) | Output unit | 10C |
(193) | a=X2.1 18/14 Air filter on engine a=X3.2/ 18/1 Air filter in front of frame ATEGO 18-26t a=X6.1 18/3 Air filter in rear frame b=X2.1 18/15 Air filter on engine b=X3.2 18/2 Air filter in front of frame ATEGO 18-26t b=X6.1 18/4 Air filter in rear frame c =X2.1 18/16 Air filter on engine c =X3.2 18/3 Air filter in front of frame ATEGO 18-26t c =X6.1 18/5 Air filter in rear frame | 54G |
(204) | Engine speed detection | 4C |
(241) | Engine brake retarder switch: 1-stage on ATEGO 18-26t, 2-stage on ACTROS and 3-stage in the case of DVB | 17M |
(266) | Signal acquisition and evaluation | 27C 36C 51C |
(268) | Signal acquisition and overspeed warning | 25C |
(273) | Voltage supply | 9C |
(276) | Disengageable voltage supply for switch | 31C |
(297) | Cruise control/Temposet switch | 35M |
(308) | v-pulse conditioning | 54C |
(312) | Lines twisted | 55F 57H 57E 60E 60I |
(350) | Optional depending on version | 6E 8E 40E 42M |