W00.00-1096-08
W41.10-1044-08
1 | Longitudinal frame member | 4 | 2nd rear axle | E | Input measurement | ||
2 | Transmission | 5 | Front axle | Pfeil | Direction of travel | ||
3 | 1st rear axle | A | Output measurement |
Remedy: |
Please enter flange angle and incline angle of drive shafts and do not fail to note the inclination direction .
Instructions for filling out data sheet
Calibrate angle gauge. For this, observe the document:"Measure flange angle of propeller shafts".
Measure flange angles of major assembles and enter in the respective field (E).
Only one flange angle need be measured for each major assembly.
Measure inclination flange of propeller shafts and enter in the respective field (E).
Please adapt the filled-in data sheet and corresponding test sheet for fault analysis on vibrations and noises on the vehicle in Xentry TIPS as case module.
Markets without Xentry TIPS fax the test sheets to the responsible contact in the MPC.
Perform measurement after repair completed, and enter into respective field (A).